APC Service Bypass Panel - 200/208/240V; 30A; BBM; L6-30P input; (2) L6-30R (2) L6-20R output

The APC SBP5000RMT2U is a service bypass panel that mounts in 2U of rack space and keeps critical equipment powered while you work on a compatible UPS. Instead of scheduling downtime, you route the load through this panel, shift to bypass mode, and perform maintenance without interrupting servers, storage arrays, or network gear.

The unit connects to a power source through a NEMA L6-30P plug and supports 200, 208, and 240 volt circuits at up to 30 amps, providing 5000 volt-ampere capacity. Its break-before-make transfer design disconnects the UPS before redirecting power, adding an extra layer of safety for both technicians and hardware.

Four locking outlets on the front—two NEMA L6-30R and two NEMA L6-20R—let you power a mix of high and moderate current devices. A 10 foot input cord gives freedom to place the panel exactly where it is needed inside the rack.

Installation is straightforward because mounting brackets and a detailed guide come in the box. Built-in circuit breakers guard against overloads, and 99 percent operating efficiency keeps energy loss to a minimum.

This panel suits small and midsize data centers, network closets, laboratories, and edge computing sites where continuous uptime matters. IT staff can replace batteries, swap a UPS, or run firmware updates without forcing a shutdown, protecting productivity and avoiding off-hour maintenance windows.

Highlights:

• 200, 208, and 240 volt input and output compatibility
• 30 amp capacity with 5000 VA load support
• NEMA L6-30P input with 10 foot power cord for flexible positioning
• Two NEMA L6-30R and two NEMA L6-20R locking outlets
• Break-before-make design enables safe UPS maintenance
• 2U rack mounting hardware and installation guide included
• Built-in circuit breakers and 99 percent operating efficiency
• Operates at 50 or 60 Hz and from -4 to 122°F